My company purchased a cmts 1000 and was wondering if someone could point me into the right direction for info on how to set this up and get it working? I have been able to set some commands but others I can't seem to figured out where to set them. Like setting the DHCP server ip address, where do you set that at?
Hello,
I have installed a fresh copy off Mandriva 2007 and then I try to run make to set up DOCSIS server. The message I get is:
[aco@localhost docsis-server-2.0.4]$ make
make -C docsis_lib
make[1]: Entering directory `/home/aco/Download/docsis-server-2.0.4/docsis-server-2.0.4/docsis_lib'
gcc -g -O2 -fPIC -I. -c -o libdocsis.o libdocsis.c
libdocsis.c:44:38: error: net-snmp/net-snmp-config.h: No such file or directory
libdocsis.c:45:32: error: net-snmp/utilities.h: No such file or directory
libdocsis.c:46:33: error: net-snmp/config_api.h: No such file or directory
Arris has sent a note letting me know that they have a Knowledge Base available at http://ask.arrisi.com. It contains links to driver downloads and modem/eMTA information such as LED status patterns. Feel free to take a look around!
We are a small ISP with 30 customers and we have to change from mmotorola to arris.
We've bought a nortel cmts 1000.
With motorola I just have to configure the CM-IpSpace and the CPE IpSpace and the dhcpserver.
Inside the dhcp we are doing the provisioning.
I think arris can do the same!
Could annyone please help me to get the arris configured or paste here a sample?
I looked inside the CLI and configured the IP Adress. I've updated the software to 3.6.2 but now I couldn't set the routing and the IP settings for the modems and the cpe's.
Hello,
I've implemented a sorely needed site update. Unfortunately, the main pages of the old site had to be locked to stop spammers from "updating" information on various CMTS systems. As a result, the information became very stale and with links to dead pages. I'll attempt to bring back current links to various docsis resources in the following weeks.
As far as I can tell, all user accounts have migrated to the new board successfully. You should be able to log in with your current credentials.
from time to time cmts is restarting itself. it happen randomly and in couple of minutes is up. interesting is, that as reload reason is power reset. but all equipment is backed up on UPS.
used firmware : SW Version: 1.0.0P49.03.TRCU, BOOTR: 1.0.25.
before, i have used 49 firmware, and happen mysterious crashes. cmts got frozen.i have to do reload command at console and restart cmts.
We have purchased a used Arris 1000 CMTS via internet, but when we turned it on, it was loaded with other settings than default.
Default username and password are not accepted, neither via console or telnet access.
I have contacted the company that sold it to us, but all they know is that it was a device bought from somebody else.
Since I do not have console access, and it is too expensive to ship the unit back to the USA from here, can anybody tell me if there is any way to reset the device back to factory settings other than through console access ?
I have a problem:
If I upload through Emta lan interface with iperf (iperf -cx.x.x.x -fk -i 1 -t 300 -u -b 1000m -P 2 ), the emta not give line. When i shutdown the iperf, telephone is work properly. If telephoning to proceed, and start iperf then ain't problem.
CM config file:
