Docsis chat

There is anybody who uses ZABBIX to monitoring the FEC?
I am new on the zabbix, I´m doing some progress catching the results of interfaces, SNR, but I´m trying to make the FEC results, no success until now

Good afternoon all,

We have been experiencing a very interesting issue lately, and I figured I'd share in case any of you ran into the same issue.

Hi,

CISCO ASR 1002 has 1+1 AC power supplies for redundancy. Pl confirm if we can use it using only one power supply, or it is mandatory to turn ON both supplies.

Hi

I am looking for the dpc3010 cox firmware to prove a firmware problem

some dpc3010 modems have upload speed problems

the one that are working well have the firmware d3000-c2000r5593-150324a-COX
the ones with upload speed problems have the firmware dpc3010-v302r12901-091119a

the problem began when I increased the upstream burst from the default to 16000

before the increase, the cox modem had the upload problem so I am in a lose/lose situation

I would like to put the same firmware in all the modems to simplify things

Hi Guys,

I wondering if anyone have a answers to my problem. When i'm connecting a new cm or a hold one have been disconnected since few months, it is always taking around 30-45min before the CMTS see it first. I know he have to scan, but i dont understand why is soo long.

On some network is soo fast.

Anyone have ideal about it ?

thanks

Basically I want to be able to give out static addresses from the same subnet to any cable modem regardless of which BSR it is connected to.

Is it possible to enable proxy arp on LAG interfaces? I am able to get proxy arp working for individual 1G/10G ports but the option doesn't look to be available for LAG interfaces.

Edit: I believe I have found a way to get this working using more specific static routes on each CMTS and am working on a more elegant solution. Would still be nice to get proxy arp working with a LAG interface

Hi guys!

I have little problems.
We installed 3 arric c3 few days ago and i got that problem if is put the cmts US to ATDMA and modulation profile 27 (qam32) then the modems suck at init(rc) and not getting dhcp. If i put it back to modulation profile 21 (qpsk) works perfect.

what can i do?

I have some TX32 cards that are showing muted after upgrading them from 8546 to 8629. On the Chassis I am currently running boot ROM of 7.0.0.43 with a firmware of 7.0.0.5 on my SRM4.

Any clue why this would happen? The front of the TX32 cards are all greened up and look happy. See below output showing that the cards are muted. Any help to figure this out would be great.

Thanks

Hi all,

I'm trying to duplicate the bandwitdh with my ubr10k using LACP, the problem is that when i configure the CMTS and the switch the traffic, alternate between two ports of the switch, cutting the service for a few seconds.

This is my config on ubr10k and switch:

UBR10K:

interface Port-channel1
ip address 192.168.123.13 255.255.255.0
no negotiation auto

Hello everyone!
today, i need setup ssh on my Bsr 64000, pls tell me how to configuration it
Thank a lot!