Using a UBR10K and NSG 9000 40G. I can't get the Depi tunnel to actually come up. I using what I thought was a very simple config just to get an understanding of how things work. I'm stumped. Have them connected directly together. Should be simple but I'm missing something obvious I'm sure.
I am trying to run Broadcast Video over Cisco cBR8 and unfortunately I have stucked on WAN side setup.
My setup is simple: got 2x DVB-C streams (multicasts) that I would like to "see" on RF Video QAMs behind CMTS.
DVB-C source works (mcasts are being sent towards cBR).
"RF side" config is done: VCG, SDG, LED, table (table based) is configured
But I can't see any traffic on video QAMs...
I got this task as our video guy has changed his job but I have never touched video...
Hi! First of all, say hello, I am new, a pleasure from Panama, I would like to help me please, I have my modem arris 1672, watch a video that donald did how to enter the arris through firefox, but I only manage to get the oid, but I cannot go any further, if someone could help me, the isp puts its own seed, nothing is the key of the day, http://10.5.0.16:8080/snmpGet?oids=1.3.6.1.4.1.4115.1.20.1.
Hi! We have some CM that when are in a 32 Channels bonding takes only one frecuency and when they are in 16 Channels works on bonding. Only happen with some cable modems and not all firmwares.
The CMTS is a CASA C10G.
We doesn't get the correct firmware from the original supplier, someone has any clue to try a workaround without configuring only 16 Channles?
Thanks!
PD: Sorry for me enligsh
We have a problem on our bsr64000 with fans. The fans spin at high speed:
bsr64000:8A#show system fans
Fan Tray Alarm Status
GLB: [10] Failed: SecondaryI2C
Top: [10] Failed: SecondaryI2C
Top: [ 0] All Fans Good
Bot: [ 0] No Current Alarms
Bot: [ 0] All Fans Good
Top Fan Readings:
ROM Rev# = 0x83
Status = [ 10]
Alarm 1 = [ 10]
Status 1 = [ 00]
ThermOff1 = [ 4]
Therm 1 = [ 137] 28C 82F
