Docsis chat

please explain the purpose of TLV-55 (SNMP CPE Access Control) parameter. When it's used and how.

What is the best way to access the spectrum analyzers in Doc 3 remotely?

I can access it when on-site at 192.168.100.1:8080

Would some of you be willing to post your doc3 cablemodem configs for higher speed plans? 100mb and greater?

Hi

After several consultations here in the forum I already have the Docsis file configured with the OID necessary to have access from the Wan to the cable modem, I also add the OID that my Seed client enables me to be able to enter the cable modem management with the password of the day, now when I try to access with the password of the day it does not give me access and in the cable modem log I have this error.

We're having issues with our cable plant (spring and fall) when the temps swing over night. We noticed the losses are much more dramatic in the upper frequencies when the temp swings. We're rural so we have much longer distribution runs than we'd like, but we'll be splitting that up with new fiber nodes soon.

Can someone share me a firmware and CVC for an Arris DOCSIS 3.0 Touchstone Data Gateway Model DG860A Cable Modem.

my current firmware is extremely old, it's from 2013.

I hope someone can share the fimware with me, thanks for the collaborations

I want to share with you a link of OID to use in Arris Cable Modem, here configure some OIDs in the DOCSIS file and they work for me, for example, access to SSH, Telnet, Web, but the OID to configure password for the user technician does not work for me, I cannot access the cable modem with this user, someone knows what can happen

https://mibs.observium.org/mib/ARRIS-CM-DOC30-DEVICE-MIB/

I have configured my CMTS as ToD Server, in the CMTS configuration I have clock timezone CST -6, when I run a show clock it shows me the time of my region, but the cable modems take UTC time which is 4 hours different from my region, someone knows how I can correct this.

We have a couple of 10ks running MC20x20 cards. We are not running m-cmts as yet but want to start getting ready.

I have dual DTI cards in one server, one needs upgraded I can't find anything on it. Should we set up dti timing or does it do anything for this setup? Is it worthwhile to go ahead and get a timer?

What is the configuration for the DTI cards and failover? Does it have any affect on our existing setup?

Thanks!

We got another set of TX32 and RX48 cards as we've expanded and added new nodes. Do I need to power down a BSR 64k to install the new cards?

I've not installed cards on a production CMTS before, so we'd like to limit downtime if we can - I also don't want to damage my CMTS.

Hi Everyone,

I am newbie in setting CM Config. Now I have CASA C2200 CMTS and Docsis 3.0 CM. I need add some snmp mib in CM Config to change the non-vol value of CM.
Below is my CM Config. Can anyone help me what snmp mib I need add in CM Config to let snmp setting work?

Thank you!

Best Regards,
Ray