Docsis chat

Hi all,

Does anybody have perhaps the Cisco RFGW-1 06.04.13 SW?
I have a bug on the 06.04.07 what solved the Cisco in the 06.04.13 revision.
vatiacg "dot" kefo "at" gmail "dot" com

Thank you.

Below is eMTA Docsis info, modem have issues with upstream channels, two channels not bonded. What can cause this issue?
+----------------------------+-------------+------------+--------------+-----------+-----------+
| Downstream Bonded Channels | | | | | |
+----------------------------+-------------+------------+--------------+-----------+-----------+
| Channel | Lock Status | Modulation | Frequency | Power | SNR |

Hi for everyone, I want to prove load balance in CMTS 10k with DOCSIS 3.0 and watch the balance in the differents bonding group of downstream but I don't know what can I do, so if everyone know some process or tests for to show this, I really appreciate...

At the first time, I conect the CMTS to 4 laptops and a server. The server send a 5 MB in a 1GB link. I wanted to saturate the link and see if the other cable modems were connected to other carriers, but I did not throw any data.

Guys, please give me a question. with the uBR10-MC5X20S linecard I can do channel bonding with the 5 downstream for a cable modem docsis 8x4 pick up at least 5 downstream channels ?

Thank you.

During eMTA device debugging and adjusting CM SNMP NonVol Settings, it seems I accidentally did set 'ResetDefault' for non-vol Dynamic Settings, which cause Resetting Dynamic Settings. In particular, docsDevSwFilename and docsDevSwServer now have default (wrong) values. I tried set correct values via SNMP MIB Browser, but settings not retained after reboot. Should these setting be applied directly via CM SNMP NonVol commands?

Anyone have any example modem configs for doing triple play with a gateway modem? I am doing some tests with the ARRIS TG3452 and am hoping to find a good starting point.

Hello everybody,
does maybe someone know what is the latest firmware version for Cisco EPC3208?
I have checked it and latest one that i have is e3200-ES-16-c1000r5593-140829c from September 2014.
If someone has any info about it, or any newer firmware version, that would be appreciated.

Thanks and kind regards

Best regards, I'm configuring bsr64000 but I do not get internet,
I have 2 modems one stays this state; online (pt) and the other one in; init (rc) but neither gets internet that could be?

Our arris C4 is redundant from 0 to 5.
However, even if 【debug slot 0 dump sparing data】 is executed, 3 to 5 information will not be displayed.

①Do you think the redundancy function is preserved?
Is it just a display problem?

②Is there a way to solve this problem?

I noticed that the display of 3 to 5 CPU utilization is wrong.
Does it concern this problem?

Short Question:
For the Arris DG3450 TG3452, and TM3402 modems, which variant of the firmware should be used? NA or D31?