Docsis chat

Hi

To be able to set the WiFi encryption type (WPA, WPA2) I am looking for the OID (Bradcom MIB).

SnmpMibObject .1.3.6.1.4.1.4413.2.2.2.1.18.1.?.?.?.?.?

Would be great, if someone can help me here.
Thank you.

Hi,

I would like to set the dhcp options in sequence. I want to obtain the same dhcp offer messege options sequence in docsis_server like in isc-dhcp-server:

dhcp offer from isc-dhcp-server

OPTION: 53 ( 1) DHCP message type
OPTION: 54 ( 4) Server identifier
OPTION: 51 ( 4) IP address leasetime
OPTION: 1 ( 4) Subnet mask
OPTION: 3 ( 4) Routers
OPTION: 4 ( 4) Time server
OPTION: 6 ( 4) DNS server
OPTION: 7 ( 4) Log server
OPTION: 82 ( 25) Relay Agent Information

Hello,

I am using Cacti Version 0.8.8b .

Is there any template for CMTS Motorola BSR64000 that shows Upstream Signal/channel and other .
I found on internet for bsr1000 but it does not work for bsr64k.

Endrit

Does anyone know the SNMP OID to access these numbers from a Cisco CMTS

Dear, I have the following error on a SPA-5X1GE-V2 card in a cmts cisco ubr10k. I'm using the ios ubr10k4-k8p6u2-mz.122-33.SCH3. can solve this or is it a hardware problem?

Hi all,

The host authorization on command on BSR is used to enforce the binding of the CM and CPE
MAC addresses to the IP address assigned to them.

Which command is the equivalent for it on Cisco Ubr?

Thanks in advance.

Good morning

I have a problem, I tell you that my cable modems do not exceed 2Mb of upload, in the tests I do only show up to 20 Mb of download but upload only 512Kb and for more than try it does not rise even a Mb, then I will detail the configuration file of my cable modem to see if any opinion or someone who has gone through the same problem gives me their support.

I will attach the Image of my Config File that I am using for my aproving.

Config CMTS C3 ARRIS

Hi All,

My log file on bsr64000 is full with entries like bellow:

Hi,

I am monitoring some cable modems using the snmp querys as follow

snmpwalk -v 2c -c public 10.58.0.41 DOCS-IF-MIB::docsIfSigQUnerroreds.3
snmpwalk -v 2c -c public 10.58.0.41 DOCS-IF-MIB::docsIfSigQUncorrectables.3
snmpwalk -v 2c -c public 10.58.0.41 DOCS-IF-MIB::docsIfSigQCorrecteds.3
snmpwalk -v 2c -c public 10.58.0.41 DOCS-IF-MIB::docsIfCmStatusResets.2

I would like to know if there is any snmp query to reset or clear this counters, instead to reboot the cable modem.

thanx!

Asaf Kolman

Hi,
If someone has experience with kind of cable modem, I need to enable remote access WAN for this cable modem.
If someone can give the mib-s will help a lot, so can apply the OID to the .cfg file.

Thank you.