Docsis chat

Hi all,
I configured an L3 "port channel" in InterGiga of BSR64K but in this channel the upper traffic is 1Gb. if the port-channel (interface lag) was configured between two interface giga. Why is my main traffic 1Gb and not 2Gb?

1)
:7A(config)#interface gigaether X/Y
:7A(config-if)#shutdown

2) Create Port-Channel:
:7A(config)#interface lag [num]

3) Assign Description and IP Address in Interfaz Port-Channel:
:7A(config-if)#description ### DESCRIPCIÓN ###
:7A(config-if)# ip address ip mascara

We're currently not using IPv6 and was wondering how to let the CMTS know that. The reason I'm asking is because I keep seeing messages like these in my logs:

[00]-USDATA2.27 Get Primary IP6 Address failed: MAC Domain 0, Fn: usdataL3CreateDhcp6RelAgtInfOpt(), Ln: 19080 errStr S_accim_NO_PRIMARY_V6_ADDR
[04]-ND.64 Unsupported ICMPv6 packet of type Router-Adv in accUssNdProc

This is on a BSR64k running 6423

Thanks!

Hello!
Cisco uBR10000 Version 12.2(33)SCJ2a
card 7/0 ubr10k-clc-mc2020v license 20X20
card 7/1 ubr10k-clc-mc2020v license 20X20
card 8/0 ubr10k-clc-mc2020v license 20X20
card 8/1 ubr10k-clc-mc2020v license 20X20
__________________________________________
cable load-balance docsis-group 800
downstream Integrated-Cable 8/0/0 rf-channel 0-3
downstream Integrated-Cable 8/0/1 rf-channel 0-3
upstream Cable8/0/0 0-3
method utilization
threshold load 85
threshold stability 85
init-tech-list 3

Hi,

I want to create a spectrum rule in which it can change the modulation of the upstream.
I know that i have to configure logical channel 1 in a different profile.
I have the configuration below but it doesn't seem to work. Can someone help me on this ?

#show spectrum rule
cable spectrum hop-period 30
cable spectrum monitor-period 30
cable spectrum cm-mode-monitor-period 45
cable spectrum back-hop-step
no cable spectrum trap
no cable spectrum syslog
no spectrum analysis full-spectrum

Does anyone know what the function of the LCD display on the Cisco uBR10K chassis is? I have never been able to get display to show anything other than the Cisco logo and the buttons don't do anything.
Thanks in advance!

Hello,
can somebody help me with firmware version V2.02.08 for the aforementioned cable modem? Or any other working version, preferably without MTA. Netgear support refused to help me stating that the model is out of warranty...

Thanks in advance!

Anyone here in the forums know how to perform manual routing in a Motorola SEM v8/v12?

Hi,
it is possible to get 8 channel bonding for US?
Some sellers says:

"
New message from: ****** (121)
Hello,

I double checked with my engineers, and they say that although some operators have reported achieving 32x8 channel bonding on the BSR64000 system, officially it is not supported.

Any idea?

Many thanks &
BR Marek

Hi folks. Wondering what everyone is using in their labs for a noise source (noise generator)? I'm still working to outfit the lab here with all the tools needed for testing. Right now my challenge is to test some CMTS features such as dynamic modulation fallback and D3.1 profiles... basically a QAM profile change operation no matter how you slice it.

What have you got and how do you like it?

Hi all