Docsis chat

Hello All,

We want to create a service flow for Cable Modem management where all cable modem management traffic goes through this service flow and does not affect data traffic.

We have added a new service flow but when pinging the modem management IP from a remote management server to the CM it does not seems to be going through this management service flow.

What is proper way to specify downstream and upstream with no speed limit in CM config file?

Looking for help from anyone who has set up automatic Speed test for FCC compliance. If you could provide some example configuration and firmware version used that would be useful.

What DHCP server do you use in provisioning your modem with SQL database back-end? beside in docsis_server (https://github.com/bschirrmeister/docsis_server), im currently searching for DHCP with SQL back-end and I see the ISC kea but I cant see any example using this DHCP, anyone with suggestions?

Hi,

It seems that, there is a way that a cpe is able to reach other modems aside from itself, how am i going to block this, any ideas? i am using c3 cmts,

Thanks in advance,

Hi!

I´m new to DOCSIS 3.0/3.1 and I have an uBR7246VXR which should be run in docsis 3 mode ! I went through forums already and compared to other router configs but somehow no modem will go online in Docsis 3 mode . Here is my config maybe someone can help me out a bit . Btw I disabled the load balance at the moment cause the modems currently running in DOCSIS 2.0 mode start to switch between frequencies .Thanks in advance !

Recent purchased Casa C10000 however I am needing the password recovery procedure.

Thanks in Advance!

Jeff

I did a quick search in regards to dual stack, being able to provide ipv4 and ipv6 and didn't see anything.
Modems used are Cisco 3.0 (majority are 8x4), the 10k is running fairly new release with 24x8 bonding. checking the spec of the modems, there's nothing on them about being able support ipv6 on the modem or cpe's behind the modem. Wanted to see if anyone ran into issues or problems going from ipv4 to ipv6

Thanks
Carl

HI,

Does anybody have configure DPON on a 10K ?

I try to make it work and when I apply the command: cable upstream dpon and do a shut/no shut, my modem disappear and wont get back.

IOS; ubr10k2-k9p6u2-mz.122-33.SCF.bin

My config is:

We have a Cisco 7200P CMTS with Version 12.2(33)SCD5 iOS.

We're using DoxControl as our provisioning software.

None of the new SB6141 will not connect to our CMTS. Anyone else have these issues?