Docsis chat

What DHCP server do you use in provisioning your modem with SQL database back-end? beside in docsis_server (https://github.com/bschirrmeister/docsis_server), im currently searching for DHCP with SQL back-end and I see the ISC kea but I cant see any example using this DHCP, anyone with suggestions?

Hi,

It seems that, there is a way that a cpe is able to reach other modems aside from itself, how am i going to block this, any ideas? i am using c3 cmts,

Thanks in advance,

Hi!

I´m new to DOCSIS 3.0/3.1 and I have an uBR7246VXR which should be run in docsis 3 mode ! I went through forums already and compared to other router configs but somehow no modem will go online in Docsis 3 mode . Here is my config maybe someone can help me out a bit . Btw I disabled the load balance at the moment cause the modems currently running in DOCSIS 2.0 mode start to switch between frequencies .Thanks in advance !

Recent purchased Casa C10000 however I am needing the password recovery procedure.

Thanks in Advance!

Jeff

I did a quick search in regards to dual stack, being able to provide ipv4 and ipv6 and didn't see anything.
Modems used are Cisco 3.0 (majority are 8x4), the 10k is running fairly new release with 24x8 bonding. checking the spec of the modems, there's nothing on them about being able support ipv6 on the modem or cpe's behind the modem. Wanted to see if anyone ran into issues or problems going from ipv4 to ipv6

Thanks
Carl

HI,

Does anybody have configure DPON on a 10K ?

I try to make it work and when I apply the command: cable upstream dpon and do a shut/no shut, my modem disappear and wont get back.

IOS; ubr10k2-k9p6u2-mz.122-33.SCF.bin

My config is:

We have a Cisco 7200P CMTS with Version 12.2(33)SCD5 iOS.

We're using DoxControl as our provisioning software.

None of the new SB6141 will not connect to our CMTS. Anyone else have these issues?

String for option 43 Required for FritzBox modem

Hi

Im doing some testing locally on my modem Have full serial acces with modem key and looking for the OID to disable VOIP on starts.
It looks that my setting get overwritten by config on boot . I want to disable that permanent
Its a Cisco EPC3928 family

thanks

We have received a newer firmware for a rather old Hitron BRG-35503 4x4 Cablemodem.
I've set alle the required configuration for upgrading the cm.
But it doesn't start to download any firmware from our tftp server.
Any hint would be helpful.

After a modemreboot I can read all necessary informations by snmp:
Name/OID: docsDevSwServer.0; Value (IpAddress): correct
Name/OID: docsDevSwFilename.0; Value (OctetString): correct
Name/OID: docsDevSwAdminStatus.0; Value (Integer): allowProvisioningUpgrade (2)