I´m thinking in building a CMTS based in Docsis_server for testing porpose but I´m not understanding how to interface the coax modem with the PC where the Docsis_server will be installed.
Thanks for your time guys, I am looking for Definitions on some of these errors (or all of them if available), as it will help me do my Job a lot better. Things Like:
Received Response to Broadcast Maintenance Request, But no Unicast Maintenance opportunities received - T4 time out
DHCP FAILED - Request sent, No response;
CISCO: RF disconnect,QAM lost.
And more, as well as looking for how we would troubleshoot such errors.
I have a strange problem with ISC DHCP. From time to time DHCP server removes IP adresess to one cable modem and gives to another one in a short period of time. It behaves like it does not have free leases. I have checked and there are more then 3000 free leases. I dont know if it is a load problem because the leases file is very big (74 Mb)? Does ISC have a load limit?
We have few BSR64000 deployed in our network. Currently we are having an issue where when we login using SSH, the response time is very very slow: for example when we issue command like show cable modem | i xxxx (last 4 digit cm mac id). We were told that it is actually a "memory-leak" issue and to solve this, we need to upgrade the image to the latest one. Its been running for no issue for 1 year plus only to have this "memory-leak" issue.
I have a BSR64K with two SRM 4 cards and an HSIM GE2/Eth8 card in slot 15 whenever I try to do a switch over to the standby SRM the system looses IP connectivity. I can no longer ping the BSR whether it be through the SRM card or through the HSIM card.
Is there some sort of command that needs to be ran so that there is no lose of connectivity after a switch over to the standby SRM. I have tried swapping the SRM cards and there was no change.
I recently became involved with the configuration of our UBR10012 CMTS for adding another 48 channels to our RFGW1. (We currently had 48 already, 40 of which are being used.) After several hours of trying to figure out what the heck I was doing, I finally got the additional 48 channels (40 of which are being used... so we have 16 unused channels on QAM 6/1 and 6/2 of the RFGW1) up and working.
Hi.
We rebooted our BSR64000 due to some memory leak issue and after it came back, one of the RX48 card stuck in "core" state. It was in "cfg" state for awhile before it rebooted again and stuck in "core" state until now.
