Docsis chat

Hi Folks,

Has anyone experienced this before with Cisco uBR10K.
I've had to roll our customers back to Casa C2200.
The modem levels are fine, no errors but looks like upload is throttled or there is a delay allocating upload slots.
I just need 2 x bonded downstreams and 1 upstream. No upstream channel bonding.

My config is as follows:

Hi Folks,

We use casa C2200 CMTS for our d3.0 platform.
I have commisioned a uBR10k and the statistics puzzle me.
I have 2 bonded downstreams active QAM64 and 1 upstream. I am using cab 8/0/1

Hi,

I have a ARRIS C3 CMTS that works fine with DOCSIS 2.0 cable modems but no DOCSIS 3.0 cable modem comes online.
I dont know what could be the reason that DOCSIS 3 CBN CH6541 cable modems stack in reject(c).

Dori

Hi guys. Thought maybe you all might have some insight into this one. I can ping an address from the CMTS itself, and from its loopback. But I cannot ping from the individual cable interface. Any ideas about the root of the problem here? I'm not understanding how the cable interface looks at routing differently than the rest of the CMTS. The problem is not from being blocked upstream, as I have another CMTS that can reach the same address, with the same source specified.

Hello all,

Can anyone tell me where I can get firmware for an Arris TG1672g and DG1670?

Thanks,
Emkowale

I have created three Service flows in a CM config file.

Service flow 1 - 100MbpsDS/40MbpsUS ( priority 0 )
Service flow 2 - 150KbpsDS/150kbpsUS ( priority 5 )
Service flow 3 - 100kbpsDS/100kbsUS ( priority 7 )

I have defined an upstream packet classifier in Service flow 3 to capture all packets coming from CM IP stack
like below and send them through Service flow 1...

Hi Folks,

Hi, we have deployed docsis 3.0 modems on our network for a while now.

Recently, we've seen modems, not many at once, getting stuck in init(o). They're staying in that state for minutes or hours. At some point, they'll come online by themselves.

We can manually accelerate the process by using baseline config files(network access, cpe number, US/DS services flows) and rebooting the modem. Depending on the modem's model, we may need to include a factory default mib in the config file.

I have a motorola BSR64000 which was removed the enable password 7 lines and enable secret 5
Now when I try to get as reports enable authentication failure

how can access the privileged mode without these lines?

Hi,

We bought a new ubr7246vxr with a Mc88V card. As soon i'm trying to configure it. I always lost the command prompt and the config mode exist automaticly and return it at the prompt.

Anyone know why ?

I'm running the IOS Version 12.2(33)SCE should be fine for no ?

Cable5/0 (idb 0xB06570C)
Hardware is MC88V (F-connector) with Integrated Up-converter
- Hardware is unresponsive or initializing

In the log, it look like the card always reboot