Docsis chat

Hello everyone , i need the lastest firmware for Pace model D5001, i have the current firmware 2.168.2.37 .
Thanks

Hello.

Can someone give me a general concept if it's possible, or what mechanism can be used to cause eRouter traffic to match the cable bundle instead of sub-bundle?

Thanks

We are starting to implement OFDMA across our cbr-8's. We are running 9.17.06.01z1 image.
issuing the command:
sh controllers upstream-cable 0/0/0 us-channel 12 displays this towards the end of the output:

Mapped to connector 0 and receiver 100
Bind to Cable0/0/0 US2
US phy MER(SNR)_estimate for good packets - 44.0 dB <<<-----------looking for this oid
Spectrum Group is unassigned
Nominal Input Power Level 20 dBmV

I know the power level is wrong, this is our lab... the level is ok for now.

I need to disable CPE Initialization in SAGEMCOM devices via config file.

does anyone have a firmware for the Technicolor EPC3949 modem and is willing to share?
preferably MGCP but can also be SIP

Hello,

can anybody tell me if there is any way to reset the device back to factory settings other than through console access?

Thanks and regards

Hi

I have a CMTS casa systems where I configure a trunk interface

interface trunk 1
xgige 6/1 mode active
xgige 6/2 mode active
xgige 7/1 mode active
ip address x.x.x.x x.x.x.x
ipv6 dad enable
no shutdown

When I check the traffic, I see that the used downstream bandwidth is similar in the 3 interfaces, but the upstream bandwidth is higher in only one of the interfaces, in the upstream it is not balancing the traffic

Hi

Please help me with the oid(SNMP) to see what modulation profile is using an Uptreans port of CMTS Casa Systems

regards!

Hello dear community,

How can I disable MTA disable MTA initialization in Ubee devices? Any OID + value for doing this?

AP

Hello ,
Is it possible to change the NetworkAccess parameter via SNMP or TR-069?

Is there a way to enable/disable CPE network access without rebooting the cable modem?