Docsis chat

Hello everyone,

Might someone could help me

I have two Wideband interfaces

Is there any solution for different CMTS's to use simultaneously the same public subnet ?
I am currently using CASA CMTS and Motorola BSR 64K.

Constantly i am facing a problem where every time i add a new CMTS or migrate a client from one CMTS to another the client is forced to change it's public ip address and doing so we have to add for each CMTS a different subnet.

Is this a thing that can be done at the dhcp server or CMTS configuration or should i configure a particular file to the modem ?

Any lead will help

Regards,
Endrit

Hello,
I'm looking to provision a TC7210 emta.
My modem have SIP firmware, but i don't have the correct sip server mib to provision it correctly.

Someone can help me regarding this issue ? My email is ced1202 at servperso dot net

Thanks you
Cedric

Hi,
I have configured modulation profile for upstream 16 QAM however modem is picking QPSK for US modulation.

modulation-profile 2
request tdma qpsk off 64 0 16 338 0 16 fixed on
initial tdma qpsk off 640 5 34 338 0 48 fixed on
station tdma qpsk off 384 5 34 338 0 48 fixed on
short tdma 16qam off 168 6 75 338 7 16 shortened on
long tdma 16qam off 192 8 220 338 0 16 shortened on

Does anyone have a valid config for the DEPI control plane on the D5 which works with a Cisco 3G60? I can't seem to get the DEPI control plane on the CMTS and edge QAM to work together.

Hi

Has anyone done a 16DS/8US docsis setup using cisco ubr10k and 3G60 cards ?

Thanks!

Good Morning,
We've migrated from a standard ISC DHCP running on Solaris UNIX to Infoblox Appliance. We've not had very good support from Infoblox and some of the Options will not directly work with Infoblox, or I haven't figured out how to get the MTA phones to work with Infoblox yet. Does anyone use InfoBlox? Do you have a sample scrubbed DHCP config from Infoblox you could post up please?

I figured it would best to start with the basics. I'm getting mixed signals on what is truly required for the CM config and the MTA config.

Hello Guys,

I would like to get some feedback regarding question that i have into my mind:

First of all is anyone using KEA DHCP for DOCSIS Modems and if yes, it would be really interesting to know if they can use and provide all different options with it.-

Hello!
There is a Technicolor TC7200 CM_Firmware: STDD.01.04
You can share the new firmware.
Perhaps it's in the firmware, in the description of the TC7200, it simultaneously supports the wi-fi 2.4G and 5G network.
On firmware STDD.01.04, only the choice of 2.4G or 5G.

Hi Folks,

Due to complications I can't go into I need a CMTS and CM config which will restrict the CM to 1 downstream channel. I've attempted this in the past following the CMTS documentation and I had no success.

The CMTS SW I am running is:

Slot12 HSIM 2-port GIGE/8-port 10/100 Ethernet (GE2/ETH8) Versions:
Boot ROM: RDN ROM Version: 7.0.0.43 Creation Date: Fri Jul 26 11:03:59 EDT 2013
Image: 6.4.2.2


Appreciate any tips.

Q.