I've run into an issue that I'm stuck at. The layout is a dual-bridge, with disabled routing:
Bridge-group 0:
Fa0/0.2 - link towards internet (VLAN tag set on the Fa0/0.2 outbound interface towards the next hop) - all IPs public
Cable1/0.1 - CPEs are provisioned here (same VLAN tag is set on the interface)
Bridge-group 1:
Fa0/0.0 - link towards the provisioning server (TFTP/DHCP/etc.) - again with a VLAN tag - the IPs are private
Cable1/0 - CMs are provisioned here (no VLAN tag)
Dear All,
Hope you will be fine and doing well. Is it possible to change the homepage of clients browser on DOCSIS 2.0 network. Basically, we have developed a website and we would like to advertise it using Homepage. so whenever the client will open the browser our website will appear over there untill and unless client will change the homepage setting.
Kindly adivce. is it possible or is there anyother way to do this.
please, if someone got some firmware links for $subject, share with me! Thanks. Can't start the modems, gets IP and no network access, it shows that the WAN side has no IP address, although it's online.
recently we've got a source of Scientific Atlanta DPC/EPC2203 modems. We run IOS version 12.3(23)BC3. As I see, there are no commands in this release configuring gatekeeper and such, I think the voip functionality is missing altogether. This normally would not be a problem, we don't intend to use voip for now, but we cannot configure EPC2203 modems, the cable-modem part awakes but lets no traffic through for the CPE. Can somebody please point us to the right direction?
Thanks in advance!
We are testing new Aironet 1552c with DOCSIS 3.0. As per specs, we got it must works in backward DOCSIS 2.0, 1.1 and 1.0. But its doesn't get online. It stucks ranging at init(rc). Is there any specials changes to be done on DHCP or tftp for this?
Is there anyway to change the interdigit timeout on a Arris TM402 using SIP. Have some users that the phone times out the entry before they can enter the full phone number. The modems are using the following for the digitmap.
Hi, We are using cisco uBR7246VXR with IOS 12.3(21a)BC8. We are in needing IEEE 802.1x to authenticate modems with our AAA servers. Till now, don't know whether our CMTS supports it or not?
Hello.
Does anyone integrated an asterisk server with PacketCable???
Right now, I am using Asterisk (SIP) with ATA equipment on my DOCSIS plant, not PacketCable, and the performance is very poor because without PacketCable, I dont have any QoS mechanism for guarantee the voice traffic. Applications like P2P make really bad the voice communication.
I like to know a way to jump to PacketCable using Asterisk, because my company does not have money to buy a CMS for an PacketCable implementation, but we have several eMTA ready for use.
I have been working on mapping and monitoring software for cable modem systems. I have created a browser based interactive mapping platform with per address mapping. I am currently still working on it, but looking for input, early adopting companies needing a complete mapping/monitoring/provisioning system.
