Docsis chat

Hello,

please, if someone got some firmware links for $subject, share with me! Thanks. Can't start the modems, gets IP and no network access, it shows that the WAN side has no IP address, although it's online.

Thanks in advance!

Hello,

recently we've got a source of Scientific Atlanta DPC/EPC2203 modems. We run IOS version 12.3(23)BC3. As I see, there are no commands in this release configuring gatekeeper and such, I think the voip functionality is missing altogether. This normally would not be a problem, we don't intend to use voip for now, but we cannot configure EPC2203 modems, the cable-modem part awakes but lets no traffic through for the CPE. Can somebody please point us to the right direction?
Thanks in advance!

Hi All,

We are testing new Aironet 1552c with DOCSIS 3.0. As per specs, we got it must works in backward DOCSIS 2.0, 1.1 and 1.0. But its doesn't get online. It stucks ranging at init(rc). Is there any specials changes to be done on DHCP or tftp for this?

Is there anyway to change the interdigit timeout on a Arris TM402 using SIP. Have some users that the phone times out the entry before they can enter the full phone number. The modems are using the following for the digitmap.

VendorSpecific
{
VendorIdentifier 0x0015a2;
GenericTLV TlvCode 69 TlvStringZero "x."; /* tlv length = 3 */
}

what are the mandatory MIB for packet cable 2.0 , where i can get it from ?

Hi, We are using cisco uBR7246VXR with IOS 12.3(21a)BC8. We are in needing IEEE 802.1x to authenticate modems with our AAA servers. Till now, don't know whether our CMTS supports it or not?

Hello.
Does anyone integrated an asterisk server with PacketCable???
Right now, I am using Asterisk (SIP) with ATA equipment on my DOCSIS plant, not PacketCable, and the performance is very poor because without PacketCable, I dont have any QoS mechanism for guarantee the voice traffic. Applications like P2P make really bad the voice communication.
I like to know a way to jump to PacketCable using Asterisk, because my company does not have money to buy a CMS for an PacketCable implementation, but we have several eMTA ready for use.

I have been working on mapping and monitoring software for cable modem systems. I have created a browser based interactive mapping platform with per address mapping. I am currently still working on it, but looking for input, early adopting companies needing a complete mapping/monitoring/provisioning system.

For a quick slide show introduction http://65.255.176.69/docmon/slideshow.php or http://65.255.176.69/docmon/slideshow.odp

NETGEAR CVG834G All-In-one Wireless Cable Voice Gateway Wlan Router Modem

Hello,

Does anyone can get me example files for SIP configuration for these cable modems.

Thank you in advance.

Best regards,
Fernando

Hello

We have an used Arrris C3 CMTS and we are performing some test before final instalation..
We have installed the CMTS, set the required parametars like ip helper address, upstream and downstream channels, frequencies, and we test 2 cable modems.

The modems have synchronized the Downstream and Upstream and they go in int(d) state…
After a while they go to offline mode but they never receive IP address...

Thank you in advance !!!