Docsis chat

Hi All,

How to confugration IP giga, ip enthernet and no shutdown fort?

Thanks so much.

Hi all,

Does anyone have a neat way to give CPEs a public static IP? There's no point in giving one to a CM. That's just a waste. They can have a private IP. In the dchpd.conf file I can statically assign a public IP using the CPEs mac address, but I want to somehow give a subscriber a public IP with only their CM mac address. Whatever they plug into that CM I want to give their Public Static IP. I know it can be done because my large monopoly provider does it. I can't let them be better than me at anything. :)

Thanks,
emkowale

Hi all,
I need help with cmts motorola bsr2000. I have cmts, a need get to cmts to default state. cmts arrived with clean CF card, and with password to "privileged exec mode". I finding out password (unfortunately).
I made next procedure. during cmts booting I press key on state "Press any key to stop auto-boot", next I press E (erase nvram flash file system) and next R (reboot with lear(longer)). Now cmts during booting finished on text: Error loadinf file: errno = 0x3c. Cant load boot file.
I need boot image or boot files, which I copy to CF card for correctly booting.

Hi,

I am searching for C4 / C4c Cacti template everywhere with no success.

I will be very grateful if anyone can share it.

Thank you in advance!

does anybody know how to manage Netgear CME31T modem via Command Line Interface? (Telnet/CLI) What commands are available?
Is there a special Diagnostic Modem vers. with shelled firmware, which allows to log onto the modem and set diagnostic switches to trace and log what is happening on the network, for tracing intermittent and otherwise difficult faults?

Hi Everyone!,

I have a cisco uBR7246VXR
Motorola C8U Upconverter
DOCSIS DS on 561MHz.
provisioned with freeBSD.
CM are Motorola SB4200 and SA WebStar for now

I have two ip pools one for cable modems 10.10.0.0/22
and another range for CPE 172.16.0.0/22
The current configuration allows two CPE behind the Cable Modem.

The situation is that cable modems receives IP address since you connect then to RF cable.
But when the CPE is an Access Point does not acquire ip.
You have to turn off the AP and turn it on again to receive IP.

Once you get ip, it takes hours working fine,

Hello,

...In eyes of a europe MSO for cable modem manufactors:

ScientificAtlanta ==> Cisco
Ambit ==> ubee
Thomson ==> Technicolor
Motorola ==> Compal

From the majors only Arris is still the same brand ;)

Hello

I've been working on setting up VOIP using ncs (packetcable) mta modems. I've been using Arris TM502G and Motorola SB5121 modems. So far, I've gotten the motorola to download the MTA config file, but I am having problems getting the Arris to ever request its MTA config.

Hello,

found out some TWG850-4U units in storage, nobody in the company knows who bought them or from where. They came with PacketCable firmware preloaded, bu we use EuroDocsis and SIP.

It would be a shame if they go to waste, and since we have no reliable Thomson dealer here (we switched to Cisco a while ago), if somebody has a eurodocsis sip firmware for these units, I would be gratefull if you could send it to me via email or post a download link for it.

My e-mail is warlord (at) blwireless (dot) net .