Docsis chat

Hello all

I am for looking somebody who can help to me whit licencen and software of CNR

here is my email roghax85 at gmail.com

thanks

Hi all,

We have some Cisco CMTS 7k, but now we bought a Cisco ubr10k. We want migrate the modems 1.x to the new Cmts and in same time implement docsis 3.0.

The docsis certificates to install in the ubr10k are the same of the ubr7k?

Tks

Hello,

I want to give Different IP addresses to WAN(of the router cable modem) and different IP addresses to CPE(PC of client).
How can I distinguish in the DHCP conf one from another? Can anyone help me please?

Regards,
Dori

Hi all,
i'm going to prepare to invest in a new CMTS system and I'm thinking to uBR10K with line card MC20x20D, but has some advice about uBR10K :
o it is not 100% D3.0 compliant and
o Cisco will planning to end-of-life this HW very soon.
o It might be It is MC20x20.
o The New Cisco CMTS should be investing in should be uBR10012 with the 3G60

such, should be selection cisco ?

Thanks!

Guys,
i want to ask, how to make cable modem D3.0 doesn't reset/ go to offline state when any RF down in wideband channel?
i use UBR10012 and configure 4 channel bonding downstream, but if any downstream fail/down, the cable modem will be reset/go to offline state and back to online state (no w-online). Any idea for it? how can make a channel bonding likes etherchannel?

Hello does anyone know what is the oid for the following command "show cable modem docsis downstream channel utilization"?

Any help will be highly appreciated

Hi,

I have a SPA card in Chassis A. Can it support to Chassis B? Can it support in different area (via IP, MPLS, etc) ?
In 1st scenario, i don't use DTI server, so it will be non-primary stream. I use primary downstream from line card.

Is it possible?

Thanks,
Hikaze

Hello!

I'm the IT manager of a small ISP and need to show a html page of suspended service to customers who did not pay your bill, but didn't how to do this?

We have a cmts Cisco ubr7226 and one pc like dhcpd and FTFP server. We assign a suspended docsis profile , but don't know how to display the page. Someone could help me?

Thank you!

Hi guys,
I have a question about Cable Modem Docsis 3.0. I have configure UBR10012 with card MC20x20v and Wideband SPA (EQAM). I want to bond it with 4 channel from MC20x20 and 4 channels from MC20x20v. Anyone can help me? because i try to config it: I have 2 interface wideband (ex: 8/0/1:0 and 3/1/0:0), so the cable modem can be online only in Wideband 8/0/1:0 (line card wideband) or Wideband (Modular Cable- SPA - EQAM).
I have configure the fiber node 1 to add all downstream channel.

Anyone can help me? how to configure it? CMIIW

Thanks,
Hikaze