If we have a BSR64000 with multiple gig links or ten gig links, how do you enable using multiple? We have a BSR64000 that is getting close to capping out the 1G link and would like to see if it's possible to distribute the load across multiple interfaces.
you can setup lag on the reg 1Gb or 10Gb interfaces as an option
interface lag 1
ip address 216.xxx.xxx.xx 255.255.255.248
bridge mode trunk
no shutdown
no ip redirects
no ip unreachables
!
interface gigaether 7/0
speed 10G
lag 1
no shutdown
!
interface gigaether 7/1
speed 10G
lag 1
no shutdown
!
interface gigaether 7/2
shutdown
!
interface gigaether 7/3
shutdown
!
interface gigaether 7/4
shutdown
!
interface gigaether 7/5
ip address 10.xxx.xxx.xxx 255.255.255.0
no shutdown
!
interface gigaether 8/0
speed 10G
lag 1
no shutdown
!
interface gigaether 8/1
speed 10G
lag 1
no shutdown
!
interface gigaether 8/2
shutdown
!
interface gigaether 8/3
shutdown
!
interface gigaether 8/4
shutdown
!
interface gigaether 8/5
shutdown
As it stands now, we set up the ip ranges for the modems and the cpe on the loopback interface, how does this change with using a lag interface?
would work the same as before. your going to take a single link and combine a second or or more to act as a whole or single.
your next hop would need to be setup for lag as well.
as for the loopback/modem/cpe network, nothing changes there