UBR10012 LACP

Hi all,

I'm trying to duplicate the bandwitdh with my ubr10k using LACP, the problem is that when i configure the CMTS and the switch the traffic, alternate between two ports of the switch, cutting the service for a few seconds.

This is my config on ubr10k and switch:

UBR10K:

interface Port-channel1
ip address 192.168.123.13 255.255.255.0
no negotiation auto

interface GigabitEthernet3/0/0
no ip address
channel-group 1 mode active
negotiation auto
!
interface GigabitEthernet3/1/0
no ip address
negotiation auto
!
interface GigabitEthernet4/0/0
no ip address
channel-group 1 mode active
negotiation auto
!
interface GigabitEthernet4/1/0
no ip address
negotiation auto

SWITCH CISCO 3560G:

interface Port-channel1
description CMTS10K
switchport access vlan 100
switchport mode access

interface GigabitEthernet0/25
description CMTS10K
switchport access vlan 100
channel-group 1 mode active
switchport mode access
!
interface GigabitEthernet0/26
description CMTS10K
switchport access vlan 100
channel-group 1 mode active
switchport mode access

Thanks for your answers.