Hi
I'm trying to run D3 modems (THG 571) on cisco ubr10k and they stuck in init(o), tftp server log (utftp on Suse 10):
Jun 1 18:08:24 catvs utftpd[19716]: connect from 10.195.32.8
Jun 1 18:08:24 catvs utftpd[19716]: CONFIG read=/
Jun 1 18:08:24 catvs utftpd[19716]: peer requests cable/1/142/58238c53f90b.out, conversion octet
Jun 1 18:08:24 catvs utftpd[19716]: peer requests option blksize, value 1448
Jun 1 18:08:24 catvs utftpd[19716]: qualified filename cable/1/142/58238c53f90b.out to /cable/1/142/58238c53f90b.out
Jun 1 18:08:24 catvs utftpd[19716]: check access to /cable/1/142/58238c53f90b.out against /
Jun 1 18:08:29 catvs utftpd[19716]: recv: Connection refused
Jun 1 18:08:29 catvs utftpd[19716]: transferred 0 bytes in 5.014671 seconds
5823.8c53.f90b 10.195.32.8 C7/1/0/U1 init(o) 3 0.00 1076 0 N
D2 modem comes online without problem. May be i need put some options to DHCP server, or to ubr config?
UBR config
controller Integrated-Cable 7/1/0
rf-channel 0 cable downstream channel-id 121
rf-channel 0 frequency 405000000 annex B modulation 256qam interleave 32
rf-channel 0 rf-power 52.0
no rf-channel 0 rf-shutdown
rf-channel 1 cable downstream channel-id 122
rf-channel 1 frequency 411000000 annex B modulation 256qam interleave 32
rf-channel 1 rf-power 52.0
no rf-channel 1 rf-shutdown
rf-channel 2 cable downstream channel-id 123
rf-channel 2 frequency 417000000 annex B modulation 256qam interleave 32
rf-channel 2 rf-power 52.0
no rf-channel 2 rf-shutdown
rf-channel 3 cable downstream channel-id 124
rf-channel 3 frequency 423000000 annex B modulation 256qam interleave 32
rf-channel 3 rf-power 52.0
no rf-channel 3 rf-shutdown
interface Cable7/1/0
downstream Integrated-Cable 7/1/0 rf-channel 0-3
cable spectrum-group 1
cable tftp-enforce mark-only
cable mtc-mode
cable cm-status enable 3 6-10
no cable packet-cache
cable default-phy-burst 0
cable bundle 24
cable upstream max-ports 4
cable upstream resiliency on-failure reset-modem
cable upstream resiliency channel-down-detect 32
cable upstream 0 connector 0
cable upstream 0 frequency 27000000
cable upstream 0 channel-width 6400000 3200000
cable upstream 0 ingress-noise-cancellation 10
cable upstream 0 description nodes AA, BB, CC
cable upstream 0 docsis-mode atdma
cable upstream 0 minislot-size 2
cable upstream 0 range-backoff 3 6
cable upstream 0 modulation-profile 221
cable upstream 0 equalization-coefficient
no cable upstream 0 shutdown
cable upstream 1 connector 1
cable upstream 1 frequency 37000000
cable upstream 1 channel-width 6400000 3200000
cable upstream 1 ingress-noise-cancellation 10
cable upstream 1 description nodes AA, BB, CC
cable upstream 1 docsis-mode atdma
cable upstream 1 minislot-size 2
cable upstream 1 range-backoff 3 6
cable upstream 1 modulation-profile 221
cable upstream 1 equalization-coefficient
no cable upstream 1 shutdown
interface Integrated-Cable7/1/0:0
description mac1 rf0
cable bundle 24
cable rf-bandwidth-percent 16 remaining ratio 100
!
interface Integrated-Cable7/1/0:1
description mac1 rf1
cable bundle 24
cable rf-bandwidth-percent 16 remaining ratio 100
!
interface Integrated-Cable7/1/0:2
description mac1 rf2
cable bundle 24
cable rf-bandwidth-percent 16 remaining ratio 100
!
interface Integrated-Cable7/1/0:3
description mac1 rf3
cable bundle 24
cable rf-bandwidth-percent 16 remaining ratio 100
!
interface Wideband-Cable7/1/0:0
description 4 ds mac 1
cable bundle 24
cable rf-channel 0 bandwidth-percent 1 remaining ratio 100
cable rf-channel 1 bandwidth-percent 1 remaining ratio 100
cable rf-channel 2 bandwidth-percent 1 remaining ratio 100
cable rf-channel 3 bandwidth-percent 1 remaining ratio 100
interface Bundle24
ip address 10.196.32.1 255.255.248.0 secondary
ip address 10.195.32.1 255.255.248.0
cable arp filter request-send 3 2
cable arp filter reply-accept 3 2
cable dhcp-giaddr policy
cable helper-address x.x.x.x