been a long time since working on one, show interface utilization to see where it's going. my money would be on ddos attack, double check acl's to block ntp, icmp and check again
odessa-c4-4# show interface utilization
Note: You must set the utilization interval to a non-zero value for the utiliza tion
to be calculated. Use the following command to set the utilization inter val:
configure cable load-interval
odessa-c4-4#
been a long time since working on one, show interface utilization to see where it's going. my money would be on ddos attack, double check acl's to block ntp, icmp and check again
odessa-c4-4# show interface utilization
Note: You must set the utilization interval to a non-zero value for the utiliza tion
to be calculated. Use the following command to set the utilization inter val:
configure cable load-interval
odessa-c4-4#
What value would i put here
C4-CMTS# show interface utilization
Polling rate (cable global load-interval) = 300 seconds
sw ver. 8.3.1.2
Thanks this resolved our issue