We are moving some cards between chassis and I cant seem to figure out how to tell the c100g that the linecard removal is intentional and to let the redundant card go back into standby.
I have removed the cards from the ha list, but it still shows the redundant cards as backing up the removed cards.
show module config still shows the old card types in the slots, but I can't find a way to set this to 'empty'
#show module config
module 0: QAM8x192 1 ofdm channel(s)
module 1: QAM8x192 1 ofdm channel(s)
module 2: QAM8x96 ofdm channels disabled
module 3: QAM8x96 ofdm channels disabled
module 4: empty
module 5: QAM8x96 ofdm channels disabled
module 6: SMM 6
module 7: SMM 7
module 8: UPS16x8
module 9: UPS16x8
module 10: UPS16x8
module 11: UPS16x8
module 12: UPS16x8
module 13: empty
Module 3 and 12 have been removed and will not be being replaced. Is there a way to set this without a reboot?