BSR64K - Speed US don't support | docsis.org

You are here

BSR64K - Speed US don't support

7 posts / 0 new
Last post
valeriob
BSR64K - Speed US don't support

Hi all,
i am traying to test the speed for DOCSIS 3.0 on BSR64k and with the downstream's speed i don't have problems but with de upstream's speed the CMTS show me this log:

[04/02-02:01:25.51- 03:CMTSMAC]<132>CMTS[DOCSIS]:<73020101>Registration rejected unrecognized configuration setting.
[04/02-02:01:25.51- 03:EVT]-W-REG.90 Rejected D1.1 CM registration, cm 2c9e.5ffc.e2c3, I201.1 Registration rejected unrecognized configuration setting.
[04/02-02:01:25.51- 03:resMgrTask]<132>CMTS[DOCSIS]:<73011301>Max Up Stream Bit Rate configuration setting unsupported.
[04/02-02:01:25.51- 03:resMgrTask]-W-I113.1 Max Up Stream Bit Rate configuration setting unsupported.
[04/02-02:01:25.47- 03:EVT]-W-REG.67 RCP Ignored: BondingCapable Modem 2c9e.5ffc.e2c3 can't register as bonded

Someone can explain me that please. in the configuration file the upstream's speed is 120Mbps.
Thanks a lot

cmcaldas
config

Post your config section of cable upstream port x/x and interface cable x/x that the modem is on.
also the modem file

valeriob
config

here it is:
interface cable 3/0
load-interval 1
cable bundle 1
no ip address
no shutdown
cable bind downstream 0,0/0/0,0/0/1,0/0/2,0/0/3,0/1/0,0/1/1,0/1/2,0/1/3
cable downstream 0 interleave-depth 8
cable downstream 0 shutdown
cable downstream bonding-group 1 0/0/0 0/0/1 0/0/2 0/0/3 0/1/0 0/1/1 0/1/2 0/1/3
cable bind upstream 0,1,2,3
cable upstream 0/0 channel-type atdma
cable upstream 0 channel-width 6400000
cable upstream 0 frequency 16800000
cable upstream 0 fiber-node NODO_M1
cable upstream 0 pre-equalization
cable upstream 0 spectrum-group spectrum1
cable upstream 0 description Nodo M1
cable upstream 0/0 modulation-profile 840
cable upstream 0 loadbalance-group Bonding_0_US
no cable upstream 0 shutdown
no cable upstream 0/0 shutdown
cable upstream 0/0 description Nodo M1
cable upstream 0/1 shutdown
cable upstream 0/2 shutdown
cable upstream 0/3 shutdown
cable upstream 1/0 channel-type atdma
cable upstream 1 channel-width 6400000
cable upstream 1 frequency 23200000
cable upstream 1 fiber-node NODO_M1
cable upstream 1 pre-equalization
cable upstream 1 spectrum-group spectrum1
cable upstream 1 description Nodo M1
cable upstream 1/0 modulation-profile 840
cable upstream 1 loadbalance-group Bonding_0_US
no cable upstream 1 shutdown
no cable upstream 1/0 shutdown
cable upstream 1/0 description Nodo M1
cable upstream 1/1 shutdown
cable upstream 1/2 shutdown
cable upstream 1/3 shutdown
cable upstream 2/0 channel-type atdma
cable upstream 2 channel-width 6400000
cable upstream 2 frequency 29600000
cable upstream 2 fiber-node NODO_M1
cable upstream 2 pre-equalization
cable upstream 2/0 modulation-profile 840
no cable upstream 2 shutdown
no cable upstream 2/0 shutdown
cable upstream 2/1 shutdown
cable upstream 2/2 shutdown
cable upstream 2/3 shutdown
cable upstream 3/0 channel-type atdma
cable upstream 3 channel-width 6400000
cable upstream 3 frequency 36000000
cable upstream 3 fiber-node NODO_M1
cable upstream 3 pre-equalization
cable upstream 3/0 modulation-profile 840
no cable upstream 3 shutdown
no cable upstream 3/0 shutdown
cable dynamic-service authorization-mode unauthorize
ip dhcp relay information option

cable downstream port 0/0
cable downstream interleave-depth 32
cable downstream power-level 460
cable downstream 0 frequency 471000000
no cable downstream 0 shutdown
no cable downstream 1 shutdown
no cable downstream 2 shutdown
no cable downstream 3 shutdown
cable downstream fiber-node NODO_M1
no cable downstream shutdown
!
cable downstream port 0/1
cable downstream interleave-depth 32
cable downstream power-level 460
cable downstream 0 frequency 495000000
no cable downstream 0 shutdown
no cable downstream 1 shutdown
no cable downstream 2 shutdown
no cable downstream 3 shutdown
cable downstream fiber-node NODO_M1
cable downstream shutdown
!

and the configuration file:

Network Access Control:on
Maximum Number of CPEs:16
Upstream Service Flow Encodings
Service Flow Reference:1
Quality of Service Parameter Set:provisioned admitted active
Upstream Maximum Sustained Traffic Rate:120000000
Maximum Traffic Burst:50000
Minimum Reserved Traffic Rate:0
Downstream Service Flow Encodings
Service Flow Reference:2
Quality of Service Parameter Set:provisioned admitted active
Downstream Maximum Sustained Traffic Rate:330000000
Maximum Traffic Burst:50000
Minimum Reserved Traffic Rate:0

cmcaldas
Wrong hardware

doing the math.. the upstream is not bonded. you have 2x8 not an rx48
so with a single upstream port @ 6.4Mhz at 64Qam, the most you can have is around 27Mbps Shared Bandwidth. regardless of the modem file. it gets rejected because the cmts knows it can't be supported.

example:

BSR3:7A#sh run cab up po 3/0
cable upstream port 3/0
cable upstream physical-delay automatic
cable upstream 0 frequency 40200000
cable upstream 0/0 channel-type atdma
cable upstream 0/0 pre-equalization
cable upstream 1 frequency 37000000
cable upstream 1/0 channel-type atdma
cable upstream 1/0 pre-equalization
cable upstream 2 frequency 33800000
cable upstream 2/0 channel-type atdma
cable upstream 2/0 pre-equalization
cable upstream 3 frequency 30600000
cable upstream 3/0 channel-type atdma
cable upstream 3/0 pre-equalization
cable upstream 4 channel-width 200000
cable upstream 4 frequency 7000000
cable upstream 5 channel-width 200000
cable upstream 5 frequency 6000000
no cable upstream 0/0 shutdown
no cable upstream 0 shutdown
no cable upstream 1/0 shutdown
no cable upstream 1 shutdown
no cable upstream 2/0 shutdown
no cable upstream 2 shutdown
no cable upstream 3/0 shutdown
no cable upstream 3 shutdown
cable upstream 4/0 shutdown
cable upstream 4 shutdown
cable upstream 5/0 shutdown
cable upstream 5 shutdown
cable upstream fiber-node FN-8
no cable upstream shutdown
BSR3:7A#

BSR3:7A#sh run int cab 3/0
interface cable 3/0
cable bundle 1
no ip address
mdrc enable
no trap-enable-if
cable bind downstream 12/0/0,12/0/1,12/0/2,12/0/3,12/0/4,12/0/5,12/0/6,12/0/7,12/1/0,12/1/1,12/1/2,12/1/3,12/1/4,12/1/5,12/1/6,12/1/7
cable bind upstream 0/0,0/1,0/2,0/3,1/4,1/5
cable dynamic-service authorization-mode unauthorize
cable dynamic-service active-timeout 60
cable dynamic-service admitted-timeout 300
no shutdown
cable downstream bonding-group 32 12/0/0 12/0/1 12/0/2 12/0/3 12/0/4 12/0/5 12/0/6 12/0/7 12/1/0 12/1/1 12/1/2 12/1/3 12/1/4 12/1/5 12/1/6 12/1/7
cable downstream bonding-group 33 12/0/0 12/0/1 12/0/2 12/0/3 12/0/4 12/0/5 12/0/6 12/0/7
cable downstream bonding-group 34 12/1/0 12/1/1 12/1/2 12/1/3 12/1/4 12/1/5 12/1/6 12/1/7
cable downstream bonding-group 35 12/1/0 12/1/1 12/1/2 12/1/3
cable upstream bonding-group 17 0/0/0 0/1/0
cable upstream bonding-group 18 0/0/0 0/1/0 0/2/0 0/3/0
cable mtc-mode
cable t4-multiplier 4
ip dhcp relay information option
host authorization on
dhcp leasequery authorization on

BSR3:7A#
BSR3:7A#scm rem bond det
Remote Query Polling: Enabled Poll Cycle: Complete

Last Poll Cycle Started: TUE APR 24 04:30:21 2018
Last Poll Cycle Completed: TUE APR 24 04:30:28 2018

Intf Chan Tx Micro
Cable Mac Address Ip Address Chan Desc Frq SNR Pwr Offs Refln
----- -------------- --------------- ------ ----- --- ---- ----- ---- -----
3/0 5819.f8fb.ca3d 10.45.0.2 12D1C0 dsPri 321 43.3 1.4 0 43
12D1C7 dsSec 363 43.3 0.7 0 43
12D1C6 dsSec 357 43.3 0.7 0 43
12D1C5 dsSec 351 43.3 0.7 0 46
12D1C4 dsSec 345 43.3 1.0 0 45
12D1C3 dsSec 339 44.6 1.0 0 45
12D1C2 dsSec 333 44.6 1.0 0 45
12D1C1 dsSec 327 43.3 1.2 0 42
12D0C7 dsSec 315 43.3 1.0 0 43
12D0C6 dsSec 309 43.3 0.9 0 45
12D0C5 dsSec 303 43.3 1.0 0 44
12D0C4 dsSec 297 40.9 1.0 0 41
12D0C3 dsSec 291 43.3 1.0 0 42
12D0C2 dsSec 285 43.3 1.0 0 44
12D0C1 dsSec 279 44.6 1.0 0 43
12D0C0 dsSec 273 43.3 1.2 0 42
U0C0L0 UCB 40 0.0 41.3 8134 0
U0C3L0 UCB 30 0.0 41.3 7983 0
U0C2L0 UCB 33 0.0 41.5 7983 0
U0C1L0 UCB 37 0.0 41.5 7983 0
3/0 acec.8058.a5e7 10.45.0.3 12D1C1 dsPri 327 40.3 2.6 0 46
12D1C7 dsSec 363 40.9 1.6 0 84
12D1C6 dsSec 357 41.6 1.8 0 84
12D1C5 dsSec 351 40.9 1.8 0 84
12D1C4 dsSec 345 40.9 2.0 0 84
12D1C3 dsSec 339 39.8 2.2 0 46
12D1C2 dsSec 333 39.8 2.3 0 43
12D1C0 dsSec 321 39.8 2.6 0 46
U0C0L0 UCB 40 0.0 41.5 9609 0
U0C1L0 UCB 37 0.0 41.5 9610 0
U0C2L0 UCB 33 0.0 41.5 9610 0
U0C3L0 UCB 30 0.0 41.5 9609 0
BSR3:7A#
BSR3:7A#

valeriob
Wrong hardware

Ok ok, thanks a lot!

cmcaldas
upgrade

what's your email?
I can help with an upgrade if you need to offer higher speeds

valeriob
upgrade

Thanks, Perfect!

Log in or register to post comments