Help with BW 3230 Switch/Control Terayon

Hello everyone,

I tried booting a BW 3230, but does not finish the booting process. Already tried the recovery with Loads system factory setup, but does not work.
Someone could help me with this problem:

BlueWave Boot Process is Starting...

Would you like to enter recovery menu (press ANY-KEY)? .................
fwdr.cuPresent = 00
fwdr.exp[0].expPresent = 00
fwdr.exp[1].expPresent = 01
fwdr.exp[2].expPresent = 01
mainBoard(type:pcb:assembly) = 02:01:00
backPlane(type:pcb:assembly) = 0f:03:0f
controlUnit(type:pcb:assembly) = 02:01:00
exp[0](type:pcb:assembly) = 00:01:00
exp[0](daughter) = 00
exp[1](type:pcb:assembly) = 0f:03:03
exp[1](daughter) = 3f
exp[2](type:pcb:assembly) = 0f:03:03
exp[2](daughter) = 3f

--------------- EEPROM. MAIN BOARD -----------------
fwdr.system.model = BW-3230
fwdr.system.part = 7900016
fwdr.system.revision = A
fwdr.system.serial = 311999999999
fwdr.main.part = 7000344
fwdr.main.revision = C
fwdr.main.serial = 311999999999
fwdr.main.mux_epld = 3800338
fwdr.main.gal_rev = 3800345
fwdr.main.ide_rev = 3800329

------------ EEPROM. EXP BOARD. Port #19 ------------
fwdr.i_exp.main_part = 7000342
fwdr.i_exp.main_revision = A
fwdr.i_exp.main_serial = 311999999999
fwdr.i_exp.gal_rev = 3800345

Downloading CU Altera Chain

Programming = 100%

Download status...Completed
stat of /nvram/pdm_log.txt failed: No such file or directory
Bringing up the boot manager: CPU tick divider is 16499.952500
Bootup manager started.

config file (/Apps/config/logapi.conf) opened
HM_Init: Started
lloader: license file exists
lloader: license loaded
lloader: Started
HM_LIB: Started
HM_MA: Started
ICC: Started
RDM: Started
RPL: Started
Database: Started
hwLibInitPerProcess() is OK.
sysUptimeInitPerProcess() is OK.
lpInitPerProcess() is OK.
EL: hwLibInitPerProcess OK.
EL: sysUptimeInitPerProcess OK
MA_Init: Started
ST: Started
HM: Started
Eventlog: Started
ipping: Started
SFM_HM: Started
SFM: sysUptimeInitPerProcess completed
hwLibInitPerProcess() is OK.
Switch Fabric I/O driver open success fd: 6
LINERATE_ADJUST=0x12
common_memory_size=0x20000
discard_thresh=0x3FF
Initializing ...
Initializing QoS FPGA
SIL version register = 0x3000
SFM: REFL: 8 ports from port 1 rate 3 SMDR 0xFF68
SFM: DSA: 4 ports from port 2 rate 2 SMDR 0x5568
NP55_init_msc.c 225: NP55_msc_version_check_no_cmi(0) failed
ATMS_init() failed
connection mesh type set to 0 (ATM)

-----Here's where it stops

Thanks to all

Marco Ixcoy