Hi,
Has somebody experience with configuring CM's to trunk different vlan's? A little bit of help in putting me in de right direction would be appreciated a lot. What I liked to try is setting up the following configuration:
2 CM's, both connected to a cisco device, let's say a cat2960 where CM's are connected to ports that are configured in trunk mode. So a trunk is established between both catalysts. CM's are registered on the same CMTS (uBR 10K).
Thanks,
Regards
Anthony
Look into MPLS over docsis cisco has docs
here
there is a smattering of documentation online about such things.
thanks for the reply
that's mostly the problem, there's a lot of information, sometimes it's hard to find something specific especially when I don't know if the things I search for exists or are possible.
Sorry my intention was not to indicate that you should look online for the answer, I was trying to let you know that there is not a lot of information out there on MPLS over docsis.
BTW an example of one can be found at the docsis_server homepage