Question about uBR10k with 20x20 linecard | docsis.org

You are here

Question about uBR10k with 20x20 linecard

4 posts / 0 new
Last post
Kalium
Question about uBR10k with 20x20 linecard

Hello,

I was wondering if anyone has ever successfully achieved a working 16x4 configuration file on the 20/20 line card. I have no issue with 8x4 bonding on two different nodes, however when I put 4 integrated controllers on the same interface, controllers 0 and 1 work fine while 2 and 3 will not bond in docsis 3.0.

Basically im just wondering if anyone has a 16x4 or 16x8 config that I could compare my work to, or if thats not possible, would it be a stacking issue?

Thanks for your help in advance.

mbowe
Haven't tried 16-way, but am

Haven't tried 16-way, but am currently using 12-way in production, works fine.

Notes :
16 way bonding requires 12.2(33)SCH1 or later. Also requires PRE4.

thenoc
12x1 config

@mbowe would you share your 12x1 working config? I'm trying to configure this as well.

mbowe
Have a look here

Here are some design tips
http://www.docsis.org/comment/5866#comment-5866

The required configuration is an extension of the 4 x mac-domains with 8-way bonding examples I have published full conf previously.

Log in or register to post comments