I started getting this error and the QAMs are not seen anymore. I just recently swapped out the QAMs with known good ones from ones that were failing and everything looked fine with the known good ones until I rebooted the unit and now I am seeing the following on bootup.
CMT TaskInit - Initializing Hardware (PCI, MUX, GigE, SPI)
FPGA 1 programmed with image /gluefpga
FPGA 2 programmed with image /dtifpga
Glue FPGA revision is 87
MB Version: 0x0021
CPLD revision is 0x08, prototype
PLL0 locked in approx 250 msec
PLL1 locked in approx 250 msec
FPGA 3 programmed with image /mpc2gx60
FPGA #4 (Altera FPP mode) abort #1 stat_went_low=T and stat_went_high=F
FPGA 5 programmed with image /muxfpga1
***FAILURE - Error programming MUX FPGA(s)
DPM Version: 0x000B
DTI FPGA revision: 0x0007
***FAILURE - Hardware Initialization Failed
GigE: Boot Code Version: , App Code Version:
Creating SW Tasks
***FAILURE - CMT TaskInit - APEX Configuration and Initialization
Do you think this is a hardware issue, or could it be possible that the config has become corrupted some how?