You are here

ARRIS C3 CMTS - D3.0 CM's in reject(c)

3 posts / 0 new
Last post
Endrit
ARRIS C3 CMTS - D3.0 CM's in reject(c)

Docsis D3.0 modem do not go beyond reject(c) status.
With the same file config the modem gets online on other CMTS, CASA & BSR.
These are the logs :
REG REQ rejected - Unrecognized configuration setting

show cable modem detail

MAC address : "D3.0 CM"
IP address : a.b.c.d
CM Subinterface : C1/0
CPE Vlan-ID/Bridge-group : -/-
Primary SID : 5
DS/US Interface : C1/0/U1.0
Timing offset : 523
Initial Timing Offset : 523
Received Power : 10.0 dBmV (SNR = 43.1 dB)
MAC Version : D1.0
Provisioned mode : D1.1
Registration Type : D1.0
Enable DOCSIS2.0 Mode : N
Capabilities : {Frag=N, Concat=N, PRIV=BPI}
Sid / SAid Limit: : {Max US Sids=0, Max DS SAids=0}
Transmit Equalizer support: : {Taps/Symbol=0, Taps=0}
Upstream Modulation : UNKNOWN
Ranging/Registration : reject(c) - registration failed, bad SF/COS
Total good FEC CW : 0
Total corrected FEC : 0
Total uncorrected FEC : 0
Broadcast-throttle drops : 0
IP-throttle drops : 0
Offending Pkts dropped : 0 (0 bytes)
Successful UCC attempts : 0
Failed UCC attempts : 0
UCC capable : Yes
Number of CPE IPs : 0(Max CPE IPs = 0)
CFG Max-CPE : 0
Flaps : 0
Stn Mtn Failures : 3 aborts, 0 exhausted
Total US Flows : 0(0 active)
Total DS Flows : 0(0 active)
Total US Data : 0 packets, 0 bytes
Total US Throughput : 0 bits/sec, 0 packets/sec
Total DS Data : 0 packets, 0 bytes
Total DS Throughput : 0 bits/sec, 0 packets/sec

What can i add/remove on the config file ?

PS : D2.0 modems go online normally

Endrit.H

cmcaldas
bpi+; modem file - speed too high?

Can you post the modem file used for both system?
the BSR, for example, is it a 64k or a 2k?

Endrit
ARRIS C3 CMTS - D3.0 CM's in reject(c)

Hi attached you will find the file we used for D3.0 and D2.0
BSR is a 64k.

Thank you!
Endrit.H

File attachments: 
docsis